Moteino wireless node original source PCB
Moteino wireless node · Felix Rusu / LowPowerLab · CC BY-SA 4.0

Radio carriers, wired network interfaces and connected controllers with two-layer source boards. Purchased modules and external hosts remain part of the original designs; ViaGrid routing and communication performance need validation.

Published open-source PCB projects

Dual Isolated USB CAN-FD original source PCB Open source · MIT

Dual Isolated USB CAN-FD

A USB interface with two CAN-FD channels, isolation and SuperCAN firmware for monitoring and generating bench-bus traffic.

Feather 32u4 RFM69 Radio original source PCB Open source · CC BY-SA 3.0

Feather 32u4 RFM69 Radio

A USB-programmable controller around a purchased RFM69HCW radio module, ready to exchange short sensor messages.

HUZZAH ESP8266 Wi-Fi Carrier original source PCB Open source · CC BY-SA 3.0

HUZZAH ESP8266 Wi-Fi Carrier

A regulator, boot controls and headers that make a purchased ESP8266 radio module usable as a small Wi-Fi controller.

Moteino wireless node original source PCB Open source · CC BY-SA 4.0

Moteino wireless node

A low-power sensor node built around an ATmega328P and a purchased HopeRF radio module, with a documented hand-assembly and test sequence.

PyPortal Pynt Wi-Fi touchscreen original source PCB Open source · CC BY-SA 3.0

PyPortal Pynt Wi-Fi touchscreen

A complete Wi-Fi touchscreen controller pairs a SAMD51 with an ESP32 module for interactive network displays.

Qwiic RFID reader carrier original source PCB Open source · CC BY-SA 4.0

Qwiic RFID reader carrier

An ATtiny84A turns a separately purchased ID-LA 125 kHz RFID reader module into an I²C interface with scan buffering, interrupts and audible feedback.

Ultimate GPS Carrier original source PCB Open source · CC BY-SA 3.0

Ultimate GPS Carrier

Read position, time and pulse-per-second signals from a purchased GPS module, with optional backup power and an external antenna.

USB to RS-485 Converter original source PCB Open source · CC BY-SA 4.0

USB to RS-485 Converter

A USB serial adapter for half-duplex RS-485 networks, with automatic transmit-enable control and several connector options.

W5500 Ethernet FeatherWing original source PCB Open source · CC BY-SA 3.0

W5500 Ethernet FeatherWing

A wired network interface that lets a separate microcontroller send and receive Ethernet traffic over SPI.

Browse these projects in the 3D PCB project directory. Open-source rows can be shallow-cloned into the git bucket. Generated board renders belong on the artifact CDN, not in git. See the hardware repository guide.